Procedure: Stainless steel bathtub
Pouring water into the tub
1. Use the prepared garden hose, duration approx. 90-120 minutes
2. The water must always be above the minimum mark, only then start the fire in the oven.
Heating in the oven (CAUTION !!! The oven and its parts are hot, there is a risk of burns)
Heating takes 3-4 hours to about 30 degrees Celsius.
1. Distribution of chips at the bottom of the furnace
2. Inserting a solid lighter (not paper). It is located in the kitchen in the gazebo.
3. Igniting a solid lighter
4. Cover the ignited solid lighter with more chips
5. Add more wood after heating
6. Add more wood after heating
7. Loading the furnace with wood also under the chimney, heating in this way until the temperature is close to the desired one
8. You control the burning intensity with the cover on the oven. The cover is hot, use a glove or wood.
- During warm-up
- Keeping the fire burning
Filtration (Always switch the valve only when filtration is off)
First use of filtering. Filtering is disabled
1.Venting - On the sand filtration, set the valve to "odvzdušnenie" - deaeration"
This will water the filtration- duration 5-10 seconds. We do not allow filtration
2. After watering, set the valve to "filtrácia" - "filter"
3. Turning on filtration - 1-2 hours per day is enough - or as needed.
Insert the plug into the socket.
4.
Inserting a disinfectant - 1x a day - max 60 minutes while using filtration. The pill is inside.
No person may be in the water during this time.
5. Turn off filtering
Disabling filtration on sand filtration. For maximum safety, remove the plug from the outlet.
In case the external water valve is damaged, there is a main water switch inside the door to shut off the water.
Check that the filtration hoses have not been disconnected to prevent water leakage.
Stir the water with a wooden paddle, as the water is warmer near the oven. Use the net for dirt on the surface of the water (flies, mosquitoes, leaves...)
